Look Keo Blade Carbon CR-MO 8-12NW pedals

Maximum power transfer!

The pedal features a carbon body and blade. The model has a Chromoly + axle and stainless steel bearings for maximum reliability. In addition to its weight, its ratio weight/power is the best in its category on the market today. Lightweight, aerodynamic and powerful, the pedal has everything you need to take it to the next level, to victory. The new Keo Blade Carbon improves the experience associated with using the blade technology on an automatic pedal. This new version is the result of experience gained during years of development technician at the Look factory and continuous improvement at daily contact with the greatest champions.

A contact area of ​​700 mm² on a carbon body.
Optimize every pedal stroke thanks to the stiffness of the technology carbon blade.
Simply the best power-to-weight ratio on the market today of road pedals.
Optimized shaft line: Increased power transfer and reliability
The shaft line of the new Blade Carbon has been completely redesigned. It is built around an oversized axle and centerline through composed of a ceramic bearing in internal position and a needle bushing centered under the bearing surface. This new construction allows to gain about 2 watts at 100 rpm minute.
The distance between the ceramic bearing and the needle bushing was increased by 25%. This provides greater stiffness to the whole axis line and, consequently, allows to improve power transmission.
The estate has also been given special attention. This has been improved by 120% for reliability and increased longevity. For this reason the new axle line receives the its outer end a new cap equipped with a gasket o-ring. Internally it is equipped with a gasket double lip.
Look axes are only approved after a 2 rotation test millions of cycles at 100 rpm with a 90 kg load on the center of the pedal and an eccentric rotation (which creates an impact at each lap). This equates to a Fernando Gaviria sprint of 1700 watts at 100 rpm for 333 hours! The test is far superior to the current standard, ISO 4210.

Very powerful support surface
To meet the needs of the most demanding cyclists, in especially those who compete, the pedal-cleat system must allow for effective power transfer thanks to a large and rigid contact surface.
The support surface of BLADE CARBON is equipped with a 67mm wide overmolded steel plate stainless. This optimizes the contact areas cleat-pedal, regardless of pedaling angle.
With 700 mm2 of support surface, BLADE CARBON offers a contact surface optimized for effectiveness and unmatched power transfer on the market.
Its power-to-weight ratio places it clearly above of the competition.

Carbon for body and blade
The use of carbon for the body and the blade allows for lighten the weight of the pedal, as well as gain rigidity for better power transfer.
Blade technology is a major technical innovation in history of the automatic pedal, as it provides numerous advantages: Lightness, aerodynamics, extremely easy attachment/release Safe.

Characteristics:
Usage: Race Segment.
Body: Carbon.
Material: Chromoly +.
Support surface: 700 mm².
Support width: 67 mm.
Tension: Pedals supplied with 8 carbon blades mounted + carbon blades additional carbon 12.
Cleats: Kéo Cleat.
Actual weight: 116 g
Weight of pedals with cleats and screws: 300 g
Distance between pedal axle and crank: 53 mm.
Axle/sole height: 14.8 mm (8.5 + 6.3 mm).
Angular freedom: 0°, 4.5° or 9° depending on the type of cleat (Black, Gray, Red).
Accessories: 2 pairs of blades + 1 pair of grey Keo Cleats + screws.
8 spring